Welltech SPCI2S Intel NetStructure SS7 Boards Manual do Utilizador descarregar pdf (Página 102)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 102

Bit 1 is used to determine whether or not to load share messages across the two link sets. It is

only used when two link sets are specified for the route. When set the MTP3 module will load

share messages for the destination equally across each of the two specified link sets. Otherwise

the MTP3 module will consider the normal link set to be the preferred link set and will only use the

second link set in the event of failure of the normal link set. The bit should be set to 1 to enable

load sharing across the two link sets or zero to disable load sharing and use preferred and

secondary link sets.

All other bits are reserved for future use and must be set to zero.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107

Sem comentários

Welltech SPCI2S Intel NetStructure SS7 Boards Manual do Utilizador Página 102